OPERATING INSTRUCTIONSModel PD100 POSITION DETECTORDESCRIPTIONThe Model PD100 Position Detector comprises a control module in a sheet metal housing an
10LIMITATION AND EXCLUSION OF WARRANTIESAll goods purchased from Prime Controls, Inc. shall be free from defects in materials, design and workmanshipu
2Control ModuleThe control module allows fast and easy setup and for diagnosis of system errors or problems.Calibration is achieved through the simple
3Probe Model Probe Diameter Min Cal Distance Max Cal DistancePM4 18 mm (0.070”) 0 mm (0”) 0.6 mm (0.024”)PM10 30 mm (1.18”) 0 mm (0”) 1.5 mm (0.060”
43. Connections to the control circuit of the machine are made through the form C output relay.This relay is powered in the OK condition. The relay p
5A two position DIP switch between the two main connectors, is visible from the connector edgeof the unit. These switches are for future expansion an
6CONFIGURATION SWITCHES AND JUMPERSA two position switch is located on the main control circuit board in the opening between thetwo connectors. These
7FIRMWARE VERSIONFrom time to time, as improvements are made to Prime products, the firmware controlling theunits is revised. When setting a unit up
8TROUBLESHOOTINGShould trouble develop, proceed as follows:1. Check AC input power to the control module 2. Check the fuse, accessible at the lower
9(6.50)(5.875)OK OUTCALIBRATEModel PD100Metal TargetPosition DetectorPRIMECONTROLS, INC.ACACRELAYPOWEROUTPUT(1.32)(0.600)15.233.5165.1149.27.9(0.31)(
Comentários a estes Manuais